Hunter RX


	Hunter RX

Standard Features:

Extra wide 24” runways for easy vehicle positioning

Air line kit is standard and built into the rack, providing connections at front and rear for air tools and jacks

Gutters guide water to side of rack away from flush mounted full floating slip plate

Louvered approach ramps offer drive-on ease in slippery conditions

Low voltage feedback system keeps runways level and safely stops if obstruction is hit

Easily control complete operation from the console

Clear access to jacks in front and rear

18-position ratcheting safety locks are level for alignment at all heights. Air operation provides quick action

Hydraulic velocity safety fuses shut down lift operation in event of pressure loss

Two lightweight aluminum movable work steps make the technician’s job easier

Chromed, hardened pins and teflon-coated bearings are used at all pin locations for long life

Separate console may be installed to the right or left, facing any direction. Mount up fo 15 feet away with optional hose covers

Available Models:

RX-9: Max Vehicle Weight 9000 lbs.

RX-9L: Max Vehicle Weight 9000 lbs.

RX-12L: Max Vehicle Weight 12000 lbs.

RX-12XL: Max Vehicle Weight 12000 lbs.

<<<Back To Lifts

Powerslide System for Hunter RX Lifts:

The new PowerSlideT slip-plate locking mechanism secures rear wheel slip-plates with the touch of a button. The technician no longer has to struggle to remove and replace slip-plate and turnplate (optional) pins for every alignment. Optional PowerSlide turnplates that lock the turnplates are also available.

A Hunter lift equipped with PowerSlide Slip-plates, combined with DSP600 sensors, allows the technician to make significantly fewer trips around the vehicle, greatly reducing alignment setup time. The PowerSlide Slip reduces the amount of trips around the vehicle from 8 to 3 trips.