Ascent Systems Vacuum Holster

Ascent Systems Vacuum Holster:
  • With its recently patented method of operation, the Vacuum Holster is the featured product for Ascent Systems.
    		•
  • The Vacuum Holster uses the negative pressure of the exhaust fan to assist in hose retraction, providing easier operation than telescopic hosedrops - at comparable cost.
    		•
  • As shown below, the Vacuum Holster can be incorporated into a rail system, or it can be suspended from traditional ductwork.
    		•
    ascent exhaust med
    ascent tailpipe
    ascent hose
    ascent holster

    Tailpipe Adapter:
  • Non-scratch EPDM rubber boot
  • Flexible boot can accommodate tight tailpipe-to-frame clearances
  • 8 1/2" x 4" opening can fit nearly all exhaust pipe configurations
  • Attachment hook device is non-scratch, with an adjustable-length feature
  • Rotational damper (operated by turning the T-handles) prevents heated/cooled air from being exhausted from the facility
  • Weight: 3 lbs.

    • Vacuum Holster Assembly:

    Exhaust Hose:
  • Lower section of hose (green) is made of a silicon composite, for 600 degrees F intermittent
  • Remainder of hose (black) is made of a neoprene composite (350 degrees F intermittent)
  • 4" diameter for the entire length results in sufficient airflow, even for large cubic inch vehicles
  • Hose is one continuous piece - no sections to become uncoupled after extended usage
  • External steel helix acts as a wearstrip, protecting the hose composite from contact with the floor
  • Light (.70lbs/ft), flexible, and easy to maneuver
  • Flame resistant
  • Note: 17', 20' and 23' lengths are standard. Fill in the hose length to complete the part number.

    • Hose Holster:
  • Stores out-of-use exhaust hoses
  • Color can be specified to match the facility
  • Made of durable polyethelene
  • Tailpipe adapter rests in two restraining notches that are cut in the lower rim of the Hose Holster
  • Hose Holster can be cut to a shorter length in the field to accommodate low ceiling applications
  • Weight: 7 lbs.
  • Standard length: 57" (4'9")
  • Granite-black is the default color. Please specify if different color is desired.
    		•
    ascent suspension

    Direct-to-Duct Suspension Kit:
  • Recommended suspension method when duct is 13' AFF or less
  • The flexible suspension strap is looped over the duct manifold
  • Hose Holster is connected to the suspension strap by two cam-grip cleats, permitting easy field adjustment of height AFF
  • Hose Holster can be cut to shorter lengths to accommodate very low-ceiling applications
  • All items and hardware are included in the kit
  • Weight: 1 lb
  • Extended Duct Kit also available
    		•
    bottom corner

    questions or comments? webmaster@vikingequip.com
    header5